Page 1 of 1

SparqEE Cellv1.0 and arduino M0 pro compatibility

Posted: Fri Nov 04, 2016 10:18 pm
by nazri94
Hello,

Im new in this community, i just started using arduino m0 pro and i want to connect it to internet by using sparqee for my final year project... the problem here is since operating voltage for m0 pro is 3.3v while sparqee is 5v, i want to know if the voltage from sparqee affect my arduino or not, since after i connect sparqee to my arduino, the arduino cannot upload sketches...im afraid if my arduino is brick since the power is different.. i connect the arduino m0 pro and sparqee by using arduino shield... thank you for your knowledge..

Re: SparqEE Cellv1.0 and arduino M0 pro compatibility

Posted: Sat Nov 05, 2016 6:56 am
by donjohnii
You're fine. Since the Arduino and CELLv1.0 both use the serial lines, you do have to disconnect it to upload sketches. Since the Uno only has 1 HW serial UART there was really no getting around this.