SparqEE Cellv1.0 and arduino M0 pro compatibility

The SparqEE CELLv1.0 device.
nazri94
Posts: 1
Joined: Sat Oct 15, 2016 9:31 pm

SparqEE Cellv1.0 and arduino M0 pro compatibility

Postby nazri94 » Fri Nov 04, 2016 10:18 pm

Hello,

Im new in this community, i just started using arduino m0 pro and i want to connect it to internet by using sparqee for my final year project... the problem here is since operating voltage for m0 pro is 3.3v while sparqee is 5v, i want to know if the voltage from sparqee affect my arduino or not, since after i connect sparqee to my arduino, the arduino cannot upload sketches...im afraid if my arduino is brick since the power is different.. i connect the arduino m0 pro and sparqee by using arduino shield... thank you for your knowledge..

User avatar
donjohnii
Site Admin
Posts: 686
Joined: Tue Jul 30, 2013 2:19 pm

Re: SparqEE Cellv1.0 and arduino M0 pro compatibility

Postby donjohnii » Sat Nov 05, 2016 6:56 am

You're fine. Since the Arduino and CELLv1.0 both use the serial lines, you do have to disconnect it to upload sketches. Since the Uno only has 1 HW serial UART there was really no getting around this.


Return to “CELLv1.0”

Who is online

Users browsing this forum: No registered users and 1 guest