Power supply and PO options

The SparqEE CELLv1.0 device.
User avatar
donjohnii
Site Admin
Posts: 686
Joined: Tue Jul 30, 2013 2:19 pm

Re: Power supply and PO options

Postby donjohnii » Tue Oct 18, 2016 12:27 am

That's actually a very good question, I just noticed a typo nobody has yet mentioned.

The datasheet is:
http://www.sparqee.com/wp-content/uploa ... et_v10.pdf

To save power if you're using a regulated source you could connect Vo 3.4-4.2V. Usually you would connect to Vin and provide an unregulated range between 4.3-5.25V. This will be regulated down to Vo at 3.5V.

Per your question, you should connect a 5V supply to Vin.

You can leave Po floating and connect your button to a ground. No need to debounce and it should be pulled to ground upon press. The best method is probably through a cap and resistor - I believe it should be a cap between Vdd-Po-button1 and a res-gnd-button2, then when button press, the res should effectively debounce and set a specific time to reset.

Return to “CELLv1.0”

Who is online

Users browsing this forum: No registered users and 1 guest