Cape for Beaglebone Black

SFC · Postby **SFC** » Fri Oct 23, 2015 7:37 am

I think it would be great if you could also produce a SparqEE CELL cape for Beaglebone Black.

Postby **donjohnii** » Fri Oct 23, 2015 7:38 am

Yup, in the works.

daghemo · Postby **daghemo** » Thu Sep 01, 2016 12:37 am

Any news on this?
I would love to use the SparqEE Cell on BeagleBone Black, the new BeagleBone Green Wireless or any BBB-compatible board.

The NimbeLink Skywire cape (see ) seems to be a valid alternative, but it seems also to be quite expensive.
I'm going to try M2M solutions from Yantrr (see ), but they are not going to have a distributor, so ordering their goods is a pain.
Yantrr also developed VIBE, a BBB variant with USB port extended to powered hub to eliminate USB device power down issues (maybe you should also consider this when working on a cape for SparqEE).

Postby **donjohnii** » Thu Sep 01, 2016 12:43 pm

Interest wasn't there on our side at this point in time.

Those look like good alternatives though! Feel free to make your own too... it would be a pretty straighforward PCB.

ChloeWemigept · Postby **ChloeWemigept** » Thu May 11, 2017 6:07 am

First of all, thank you for this great software. If anyone can help to post installation guide for upmpdcli on beaglebone black please...

SparqEE Forum