Can't find where to screw-on the Cellv1.0 antenna

[jerrywrice]

I've just received my CELLv1.0 and SparkEE daughter board after waiting multiple weeks. The external antenna which was included has a screw-on threaded brass connector (~ 3/8" diameter). I can't find anywhere on the shield, CELLv1.0 module, or my Raspberry Pi+ module to attach (screw on) the antenna. I might be going blind, but ???

[donjohnii]

Sorry for the wait - I'm assuming that was an RS Components buy? Was it an ok process otherwise?

For the antenna, you're not blind, check out this picture from the SparqEE website:


The screw-on connector is an SMA and the CELLv1.0 side is a W.FL - so you have to attach the jumper cable between the CELLv1.0 and the SMA plug. All the boxes should come with one.

[jerrywrice]

Thanks, got it. And yes the delay was on the RS Components side ...

Jerry

[REGSteve]

I need help. The wire to my cellv1.0 is broken. I accidentally pulled it out of the W.FL socket. Is this the correct replacement?

[donjohnii]

Yea, that looks like it would work.

[REGSteve]

Sorry to trouble you again. But that shipping cost for that website is too expensive. Will this cable do?

[donjohnii]

[REGSteve]

Mouser and Digikey are way too expensive. The shipping costs around 20 to 30 dollars. As for amazon, i not planning to buy 30 dollars worth of items at the moment. I found this on ebay through:

[donjohnii]

Yea. That should work.